Here's the output from dmesg | grep rtl_chip I think it's different on this updated model. So a heads up to anyone with a new WZR-HP-G300NH with A2 on the back it does not work yet. I have to tftp ddwrt or the official firmware to unbrick it wich is no problem, I tried Openwrt and same problem. I can't get an ip out of it to telnet or SSH into it. when installed with tftp or the mtd method, it installs fine as does ddwrt and the official firmware unfortuantly the router will brick with no Ethernet ports registering.
#DD WRT V24 SP2 BUILD INSTALL#
I have tried to install gargoyle to give it a try because it sounds awesome. I just bought from the USA printed on the back it has "A2 A0" looks like new WZR-HP-G300NH are slightly different. Now you can go back/forth within about 20-30 minutes.Ĭurrently running a Buffalo WZR-HP-G300NH A2 A0įirmware Version DD-WRT v24SP2-EU-US (08/19/10) std - build 14998 Link to the other thread so that you can go from To 192.168.1.1 - and you can set default user/passwordįor DD-WRT and start configuring - or from here, you canįlash back to the default buffalo firmware. Now - refresh DHCP if necessary and login via web page What showed under Gargoyle / OpenWRT - that's good! I have been running this build of DD-WRT as recommended by the install guide way back when: DD-WRT v24-sp2 (07/22/09) std (SVN revision 12548M NEWD Eko). WZR-HP-G300NH - you should see a different light pattern than The web browser - just leave the computer for 10 minutes.Īfter 10 minutes, close the browser and visually check the WAIT 10-15 minutes - LEAVE the router alone and do NOT close Once you upload it - it will come back with an MD5 checksumĪnd it will say its ready to flash - so hit ok/start and now
#DD WRT V24 SP2 BUILD UPGRADE#
Goto the Admin tab and choose to upgrade firmware, and nowĬhoose the DD-WRT MULTI file that you hex-edited. only test builds The link asks for username and password, how can i enter Going to go out on a limb here, but Im pretty sure that the eko builds for the most part are no longer there. You may have to renew DHCP if you changed default settings.Īfter 5 mins - logon to 192.168.1.1 in a browserĭefault logon is root - password is blank - login DD-WRT v3.6 Netgear R7800 DD-WRT v3.6: Back to top: Doramius DD-WRT User Joined. Changelog Thank you devs Back to top: Sponsor: malmo DD-WRT User Joined: Posts: 138: Posted: Wed 17:12 Post subject. Sysupgrade file - flash it and wait for about 5 mins Posted: Wed 17:09 Post subject: v24 pre-SP2 build 10776 Eko: Get it here. Open up the Gargoyle GUI - flash the OpenWRT 10.03.1-rc4 WAN cable from the router - just have a LAN hookup. Once you have those 2 files downloaded - disconnect the Remove the first 28 bytes and have these 4 bytes at the start:
#DD WRT V24 SP2 BUILD HOW TO#
Information on how to edit the DD-WRT bin file so that you Openwrt-ar71xx-wzr-hp-g300nh-squashfs-sysupgrade.binĭownload #2 - Get one of the latest DD-WRT - MULTI imagesįor the WZR-HP-G300NH - and you have to hex-edit it. It involves a few steps and a few downloads. Some people have asked about this so I tried it myself.